5 tips to prevent the engraving machine from malfunctioning

  First, the engraving machine spindle as a core component, first of all if there is rust and blockage, this will cause the machine to not operate properly, because the coolant in the coolant tube remains in the inside when we are not using it, and That is, the water also contains a large amount of elements. After high temperature, it will gradually form heavy water. The heavy water contains a large amount of impurities, which will form dirt and form rust and blockage after being precipitated; therefore, the outer surface of the electric spindle should be coated with anti-rust oil; Cool the water and prevent the water temperature from being too high, and also ensure the cleanliness of the cooling water, which can prevent the main shaft from being blocked.
    Second, if the cooling system of the engraving machine is not grounded, it will cause the power to drop, the cold head will fall off, and the life will be greatly shortened. In serious cases, the equipment will not start working. In order to avoid such problems, we It is necessary to clean the water tank and the waterway frequently, and also to properly control the temperature control point of the temperature control water tank.
    Third, if the fan and air duct are not cleaned, a lot of smoke and dust will not be discharged inside. At this time, the lens and the laser tube will be seriously polluted. Finally, the mechanical and electronic components are oxidized to cause poor contact. That is why the engraving opportunity is slow to respond.
    Fourth, the focusing mirror and the mirror should also be checked regularly, because the frame is easy to heat up. If it is not treated in time, it will cause oxidation on the surface. It will rust after a long time, especially the atmospheric pump. Users of air compressors should check the lenses on time to avoid irreparable situations.
    Fifth, in order to keep the engraving machine in the best working condition, first of all, let its power supply heat remain smooth, but also reasonable, the current should be kept within 50%, and vice versa is the result of the increase of the failure rate.